System Administrator Procedures; Placing The Local System In Day Or Night Mode; Placing Network Nodes In Day Or Night Mode - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL

System Administrator Procedures

With a System Administrator phone, you can perform the following procedures:
•
•
•
•
•
•
•
•
•
•

Placing the Local System in Day or Night Mode

You can use a System Administrator phone to place the local node in day or night mode. The
day or night mode selects preprogrammed database lists to determine trunk access, toll restric-
tion, emergency outgoing access, etc. for the phones in the system. Active calls are not affected
when the Day–Night mode is changed.
To view Day–Night Mode status:
While on-hook, enter the Night Ring On/Off feature code (9860). You hear a single confirma-
tion tone. The display shows NIGHT MODE IS ON (or OFF). If night mode was turned on,
the display shows THE SYSTEM IS IN NIGHT MODE until day mode is turned on.

Placing Network Nodes in Day or Night Mode

You can use a System Administrator phone to place one or more nodes in day or night mode.
The day–night mode determines which lists the system will use for trunk access, toll restric-
tion, etc.
The network determines the day/night mode status of a call based on the day/night mode status
of the node where the trunk resides.
To turn night mode on:
1.
2.
To turn day mode on:
1.
2.
Placing the Local System in Day or Night Mode
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Place the local node in night or day mode
Place other network nodes in night or day mode
Set the date and time of the local node
Set the network date and time
Synchronize clocks in the network
Make database changes (see
Enable, disable, and reset local and off-node call processing application modems
Program System Speed Dial numbers on the local node
Receive and clear displayed system and network alarms
Use diagnostic mode features:
— Freeze and unfreeze the database history for the local node or any node in the net-
work using programmed freeze zones
— Print error logs
— Seize specific devices for troubleshooting purposes
While on-hook, enter the Enable Network Night feature code (9861).
When prompted to enter a node number., enter 01–63 for the desired node number. To
select all nodes, enter 00.
You hear a single confirmation tone. The display shows NIGHT MODE IS ON. Then
the display shows NODE X IS IN NIGHT MODE until day mode is turned on.
While on-hook, enter the Enable Network Day feature code (9862).
When you are prompted to enter a node number, enter the desired node number.
You hear a single confirmation tone. The display shows DAY MODE IS ON.
page 26 for a list of programming areas)
Administrator Procedures
Page 23