Inter-Tel CS-5200 Administrator's Manual page 140

System Features
®
INTER-TEL CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Table 19.
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off
Do-Not-Disturb Override
Enhanced Speakerphone Enable
Feature Key Default
Group Listen
Handsfree On/Off
Headset Enable
Headset Disable
Headset On/Off
Hold – Individual
Hold – System
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace
Page 122
Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE
370 The Do-Not-Disturb feature code halts all
371 intercom calls, transferred calls, and pages to
372 the endpoint. The Cancel code returns the
endpoint to normal operation. The on/off code
can be used to turn Do-Not-Disturb on or off.
(Inter-Tel endpoints use the DND button.)
373 (Not used on single line endpoints) If enabled
in the database, allows the endpoint user to
break through another endpoint's Do-Not-Dis-
turb mode when placing an intercom call
310 (Digital endpoints only) When entered at a
digital phone, this feature code enables the
enhanced speakerphone as described in "Dis-
play and Nondisplay Digital Phones'' on
page 102
. Digital endpoints can also use the
Special button + Speaker buttons.
395 (Not used on single line endpoints) endpoints
have user-programmable feature buttons that
can be set to enter feature codes. This code
returns the user-programmable buttons to the
database default values.
312 (Not used on single line endpoints) Allows a
user to transmit a conversation over the end-
point speaker while in handset or headset
mode
319 (Not used on single line endpoints) Disables/
enables the endpoint's handsfree intercom
answering. Incoming intercom calls ring as pri-
vate calls if handsfree answering is disabled.
315 (Not used on single line endpoints) The
316 enable code signals the system that a headset
317 has been connected to the endpoint. The dis-
able code returns the endpoint to normal oper-
ation. The on/off feature code can be used to
toggle the feature on or off.
336 Places a call on hold so that it can be picked
up directly at that endpoint or through a
reverse transfer from any other endpoint.
(Inter-Tel endpoints use the HOLD button.)
335 Places an outside call on system hold. It can
be picked up directly at any endpoint that has
an individual trunk button and has allowed-
answer and/or outgoing access for that trunk,
or by the endpoint that placed it on hold. (If
used on conference or intercom calls, the sys-
tem places the call on individual hold.)
322 Removes the endpoint from its assigned hunt
323 group(s) or places it in again. Does not affect
324 non-hunt group calls. The remove/replace fea-
ture code can be used to toggle the feature.
DEFINITION
Endpoint Feature Codes