Changes To Issue 1.1; Intended Audience; System Administrator - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL

Changes to Issue 1.1

In addition to the content of Issue 1.0 of the Inter-Tel CS-5200/5400 Communication Servers
Administrator Guide, Issue 1.1 contains new information and related instructions, and identi-
fied errors have been corrected.
Information and related instructions about the following hardware and software features have
been added:
•
•
•
•
•
•
•
•
•
•

Intended Audience

This guide provides information and procedures for carrying out typical System Administrator
and Voice Mail Administrator tasks.

System Administrator

System Administrators typically perform the following tasks:
•
•
•
•
•
•
•
Any Inter-Tel phone can be designated as a System Administrator phone through Database
Programming. However, to facilitate programming and to manage alarm messages, Inter-Tel
recommends using a Model 8660 Six-Line Display IP phone or a Model 8560, Executive, or
Professional Six-Line Display digital phone for this purpose. System Administrator features
are described in detail beginning on
System Administrator
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Digital Expansion Interface (DEI) equipment
Digital Endpoint Module (DEM-16)
Digital phones
Single-Line Adapters (SLA), each of which supports two single line analog phones, or
analog endpoints such as fax machines or recording machines
Four-trunk Loop Start Module (LSM-4)
Basic Rate Module (BRM-S) that supports Basic Rate Interface (BRI) trunk capabilities
Modem Data Port Module (MDPM)
Personal Computer Data Port Module (PCDPM)
Network Address Translation (NAT) traversal
Off-Hook Voice Announce
Place the local system or other systems in the network in night or day mode
Set the date and time of the local system
Set the network date and time and resynchronize clocks in the network
Make database changes, as described in "Programming the Database Using a System
Administrator Phone'' on page
Program System Speed Dial numbers on the local system
Receive and clear displayed system and network alarms
Use diagnostic mode features to:
— Freeze and unfreeze database history on the local system or other systems in the
network.
— Print error logs.
— Seize specific devices for troubleshooting purposes.
— Report audio problems to your installer/technician.
26.
page 23.
Document Overview
Page 3