Toll Restriction - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL
6.
7.
Station Programming
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
b. Endpoint Information: This option allows you to select an Attendant for the end-
point or program the endpoint's username. To select it, press
menu button. The display shows ENTER ENDPOINT INFO OPTION. Select
INFO
one of the following:
1.) Attendant: To assign an Attendant to serve this endpoint, press
menu button. The display shows ENTER ATTENDANT
ATTENDANT
EXTENSION. Enter the desired extension number. When the circuit informa-
tion is displayed, press
OPTION prompt. The display shows DATABASE UPDATED. (Or, to cancel
your entry, press
FORMED.)
2.) Username: To change the username of the endpoint, press
menu button. The display shows ENTER USERNAME. Enter the new
NAME
name as described on
. The display shows NO UPDATE PERFORMED.)
CEL
c. Toll Restriction: This option allows you to set the endpoint class of service for day
and/or night modes. To select it, press
ton. Then do the following:
1.) The display shows TOLL RESTRICTION OPTION. Press
DAY menu button to program day mode toll restriction. Or, press
menu button to program night mode toll restriction.
COS NIGHT
2.) The display shows SET DAY (or NIGHT) COS XX. If this is not the COS
you want to program, scroll to the correct COS by pressing the high end of
the Volume button or
ume button or PREVIOUS
COS, refer to page
The default COS numbers are provided in Table .
Table 5:
Default Class of Service (COS) Numbers
COS 02 – Deny Area/Office
COS 03 – Deny Operator
COS 04 – Deny Toll Access
COS 05 – Deny International
3.) When the correct COS is displayed, press
enable the toll restriction. Or, press
4.) If desired, repeat preceding
restrictions.
5.) Press or
ACCEPT
#
DATABASE UPDATED and then returns to the TOLL RESTRICTION
OPTION prompt.
6.) Press
again to exit to the ENTER ENDPOINT OPTION prompt.
#
When the display shows ENTER ENDPOINT OPTION, press
ENTER ENDPOINT EXTENSION prompt. You can then program another endpoint by
repeating these steps or press
BASE OPTION prompt.
When finished with all programming, press
OPTION prompt is displayed. This ends the programming session.
again to return to the ENTER ENDPOINT INFO
#
or CANCEL . The display shows NO UPDATE PER-
page 26. (Or, to cancel your entry, press
or the
3
NEXT to scroll forward, or press the low end of the Vol-
to scroll backward. For more information about
158.
COS 06 – Deny Equal Access
COS 07 – Deny Local Calls
COS 08 – Denied Numbers
COS 09 – Allowed Numbers
or the
OFF
2
step 2 and step 3
to save the COS programming. The display shows
or ACCEPT once more to exit to the ENTER DATA-
#
while the ENTER DATABASE
#
Administrator Procedures
or the
ENDPOINT
2
1
or the USER-
2
or

TOLL RESTRICTION

menu but-
or the
1
2
or the ON menu button to
1
menu button to disable it.
to program additional COS toll
again to exit to the
#
Page 29
or the
CAN-
COS
or the