Inter-Tel CS-5200 Administrator's Manual page 141

INTER-TEL
Table 19.
LCD Contrast Adjustment
Message
Message – Cancel
Message – Cancel Current
Message – Silent
Mute On/Off
Page
Page On/Off
Program Buttons
Program Endpoint Password
Queue Request
Endpoint Feature Codes
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION
303 (Model 8620/8622, 8660, or 8662) Adjusts the
LCD contrast on the display. The endpoint
must be idle to use this feature.
365 This feature code is used for leaving and
retrieving a message waiting indication at a
called endpoint or the called endpoint's mes-
sage center. Depending on how the message
was left, the called endpoint user either
retrieves the message from his/her message
center or from the endpoint that left the mes-
sage. (Inter-Tel endpoints use the MSG but-
ton.)
366 Allows the endpoint user to cancel a message
waiting indication that he or she left at another
endpoint.
368 Cancels a message waiting indication that is
waiting at the endpoint without requiring the
user to respond to it. (Inter-Tel endpoints can
use the asterisk [*] button while viewing the
message.)
367 Leaves a Message Waiting indication at a
endpoint without first placing an intercom call.
314 (Not used on single line endpoints) Turns the
microphone on or off during a call. If muted,
the endpoint user can hear the other party, but
the party cannot hear the endpoint user.
(Inter-Tel endpoints can also use the MUTE
button.)
7 When followed by a paging zone code (0–9 or
0–49), it allows announcements to be made
through endpoint speakers and any external
paging speakers in the page zone.
325 (Not used on single line endpoints) Halts
pages through the endpoint speaker or allows
them to be received again.
397 (Not used on single line endpoints) User-pro-
grammable feature buttons and Station Speed
Dial buttons can be programmed using this
feature code.
392 The endpoint password is used for the
Remote Programming feature. The password
can be changed by entering the Program End-
point Password feature code at the endpoint
or when using the Remote Programming fea-
ture.
6 Requests (or cancels) an automatic callback
when a busy trunk or endpoint becomes avail-
able.
System Features
Page 123