Attendant Recall - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL

Attendant Recall

When a call is placed on hold or is transferred from one endpoint to another, the Hold and
Transfer timers limit the amount of time the call may remain unattended. After that time, the
call recalls the phone that transferred it or placed it on hold, and the Recall timer is started. If
the call remains unanswered at the endpoint until the Recall timer expires, it recalls the end-
point's Attendant and the Abandoned Call timer starts.
If there is no Attendant, the call continues to recall at the endpoint that transferred it or placed
it on hold. If the Attendant phone is busy, the call camps on and the display shows the source
of the recall. If the call is not answered before the Abandoned Call timer expires, the system
disconnects the call.
If an Attendant phone transfers a call and it is not answered before the Attendant Transfer
timer expires, it will recall the Attendant phone.
If a phone user transfers or forwards an outside call to an outside phone number, it becomes an
"unsupervised" CO-to-CO call because no inside parties are involved. The CO-to-CO call is
limited by the Unsupervised CO timer. When the timer expires, the call recalls the primary
Attendant phone and causes the
VISED CNF RECALL. This serves two purposes:
•
•
When a recall rings at the Attendant's phone, a Call or individual trunk button flashes at the
medium rate.
If the Attendant has calls forwarded, recalls from phones follow internal call forward requests.
Recalls do not forward to outside phone numbers, but recall the Attendant's phone until they
are answered or the Abandoned Call timer expires. Placing the Attendant's phone in Do-Not-
Disturb does not block recalls or direct ring-in calls.
If there is not a primary Attendant, recalls remain at the phones and ring until answered or dis-
connected by the system.
To answer a hold or transfer recall at an Attendant phone:
When you see a hold or transfer recall display (XXXX RCL FROM YYYY) and hear a recall
ringing:
1.
2.
Attendant Recall
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
be arranged in a hierarchy. That is, one Attendant may be the Attendant for another. In
this case, the "serving" Attendant is reached by dialing 0 at the "served" Attendant.
It allows the Attendant to monitor the length of CO-to-CO calls. When a CO-to-CO call
recalls, the Attendant can disconnect the call or allow it to continue.
If the callers hang up before the Attendant receives the recall, the system may not have
disconnected the trunks because a disconnect was not received from the central office.
The Attendant must disconnect the call.
If desired, lift the handset.
Outside call recall: Press the medium-flashing Call button or individual trunk button.
Or, press the button. (If more than one trunk is recalling, pressing the
ANSWER
button selects the outside call indicated on the display.)
ANSWER
Intercom call recall: Press the
are busy when the intercom call recalls, it will camp on. The
the medium rate, but you do not hear recall ring signals.)
Conference call recall: Press the flashing
ence call. The button flashes slowly and the display shows CONFERENCE IN
CNF
PROGRESS. If the parties are still talking, press the
to return the parties to their conversation. The
conference at any time by pressing the fluttering
button to flash. Display phones show UNSUPER-
CNF
button or the
IC
button to connect with the confer-
CNF
button flutters. You can enter the
CNF
CNF
System Features
ANSWER menu button. (If you
button flashes at
IC
button again and hang up
CNF
button. If the Hold timer
Page 133