Feature Codes; Ip Phone Flashing Light Indicators - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL
Table 12:
FEATURE NAME
Show Version
Diagnostics–
Show Version
Voice mail displays: In SIP mode, voice mail displays are not supported, however, the user
will still receive audio prompts.

IP Phone Flashing Light Indicators

The phone Call buttons, trunk buttons, Speed Dial buttons, Hunt Group buttons, and some of
the feature buttons contain light-emitting diodes (LED). LED flash rates indicate the status of
the endpoints, trunks, and features.
For phones operating in ITP or SIP mode, the following table summarizes the meanings of the
LED flash rates in interruptions per minute (IPM).
Table 13.
BUTTON
ANSWER
CALL
CNF
DND
IP Phone Flashing Light Indicators
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Feature Codes with Different Meanings for ITP and SIP Modes
FEATURE
CODE
9928
[9128 in
Europe]
Flashing Light Indicators for IP and Multi-Protocol Phones
STEADY SLOW
0 IPM 30 IPM
Call is
active
The LED
flashes for
2–5 sec-
onds and
then goes
out when
the confer-
ence is
estab-
lished.
Phone is in
Do-Not-Dis-
turb.
Hardware and Endpoints
ITP MODE
Displays the version Displays the firmware
and date of the call version on the phone.
processing software.
MEDIUM FAST
120 IPM 240 IPM
Models
8620 and
8662:
Intercom,
recall, con-
ference,
camped on,
or trans-
ferred call is
ringing-in.
Call is Call or
recalling queue call-
from hold or back is ring-
transfer ing in or
camped on
(waiting)
Conference
is recalling
your phone.
SIP MODE
FLUTTER
60/960 IPM
Call is on
hold at the
user's
phone or
the user
has entered
a transfer
feature
1
code.
A confer-
ence party
is on con-
ference wait
hold.
Page 87