Default Endpoint - Inter-Tel CS-5200 Administrator's Manual

System Features
®
INTER-TEL CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
3.
4.
5.
6.

Default Endpoint

An endpoint user can enter one feature code that will return the following features to their
default states. Returning an endpoint to default:
•
•
•
Page 242
Enter the extension to be forwarded. If you have a display, it shows ENTER PASS-
WORD. If you entered an invalid extension number, you will hear reorder tones and can
try again.
Enter the extension's password, followed by
FEATURE CODE.
If you enter an incorrect password, the display will show INVALID PASS-
NOTE
WORD, and the call is disconnected. Station users will hear reorder tones.
To turn on Call Forward:
a. Enter one of the following Call Forward feature codes. If you entered an invalid
feature code, you will hear reorder tones and can try again.
Call Forward All Calls
Call Forward If Busy
Call Forward If No Answer
Call Forward If No Answer/Busy 358
a. Enter the forwarding destination. This can be an extension number or a trunk
access code followed by an outside phone number.
If the forward destination is an extension number, programming is complete, and
the call is disconnected automatically.
If the forward destination is an outside number, hang up to complete program-
ming.
If the station is not permitted to forward to the destination entered, you will hear
reorder tones and can try again.
If you hang up before entering a forward destination, the programmed forward
is canceled.
To turn off Call Forward: Enter 355 and then hang up instead of entering a destina-
tion. You hear a confirmation tone.
Cancels the following features, if in effect:
— Do-Not-Disturb
— Manual Call Forwarding
— Queue Request
— Account Code for All Calls Following
— Background Music
— Ring Intercom Always
— Headset Mode
Restores the following features, if disabled:
— Handsfree
— Page Receive
— Hunt Group Replace
— System Forwarding
Returns endpoint volumes to default levels
. If you have a display, it shows ENTER
#
355
357
356
Default Endpoint