Using The Last Number Saved Feature - Inter-Tel CS-5200 Administrator's Manual

System Features
®
INTER-TEL CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Nondisplay System Speed Dial numbers cannot be redialed at a display endpoint.
Table 32.
Endpoint Status When
Idle
Intercom dial tone (on- or
off-hook)
On an intercom call
After selecting a trunk but
before dialing
After selecting a trunk and
dialing one or more digits
On an incoming outside
call

Using the Last Number Saved Feature

Use the following procedures to save and redial numbers at stations that are programmed to
use the Last Number Saved feature.
To save a number on a station programmed for last number saved:
To redial a number (last number saved):
Page 232
Redial Interactions
Endpoint Programmed for
User
Activiates Redial
Saves the last trunk access
code and phone number that
was dialed.
Saves the last trunk access
code and phone number that
was dialed.
Releases the current call,
seizes a trunk using the saved
trunk access code, and dials
the saved phone number.
Redials the saved phone num-
ber on the currently selected
trunk, instead of the saved
trunk access.
Releases the current call,
seizes a trunk using the saved
trunk access code, and dials
the saved phone number.
Releases the current call,
seizes a trunk using the saved
trunk access code, and dials
the saved phone number.
NOTE The saved number is replaced each time you repeat this procedure.
Inter-Tel endpoints: While the endpoint is idle or while listening to intercom dial
tone, press the button, or press the Special button and enter the Redial feature
REDIAL
code (380). You hear a confirmation tone, and the display shows LAST OUTSIDE
NUMBER SAVED.
Single line endpoints: Lift the handset and enter the Redial feature code (380). When
you hear the confirmation tone, hang up.
Inter-Tel endpoints: While on a call or after selecting a trunk, press the
ton, or press the Special button and enter the Redial feature code (380). Refer to the
Last Number Saved
Using the Last Number Saved Feature
Endpoint Progrmmed for
Last Number Dialed
A trunk is selected using the
same trunk access code as
used to place last outside call,
and the last phone number is
dialed.
A trunk is selected using the
same trunk access code as
used to place last outside call,
and the last phone number is
dialed.
Releases the current call,
seizes a trunk using the access
code used on the last outside
call, and dials the last phone
number dialed.
Redials the last phone number
dialed, using the currently
selected trunk.
Releases the current call,
reseizes the trunk (using the
access code used on that call),
and redials the digits that were
dialed.
Releases the current trunk,
seizes a trunk using the same
trunk access code used on the
last outgoing call, and dials the
last number dialed.
REDIAL
but-