Show Monitor - Cisco Catalyst 3750 Metro Command Reference Manual

show monitor

show monitor
Use the show monitor user EXEC command to display information about all Switched Port Analyzer
(SPAN) and Remote SPAN (RSPAN) sessions on the switch. Use the command with keywords to show
a specific session, all sessions, all local sessions, or all remote sessions.
Syntax Description session
session_number
all
local
range list
remote
detail
Command Modes User EXEC
Command History Release
12.1(14)AX
Usage Guidelines The output is the same for the show monitor command and the show monitor session all command.
Examples This is an example of output for the show monitor command:
Switch# show monitor
Session 1
---------
Type : Local Session
Source Ports :
RX Only : Fa1/0/1
Both : Fa1/0/2-3,Fa1/0/5-6
Destination Ports : Fa1/0/20
Encapsulation : Replicate
Ingress : Disabled
Session 2
---------
Type : Remote Source Session
Source VLANs :
TX Only : 10
Both : 1-9
Catalyst 3750 Metro Switch Command Reference
2-568
show monitor [session {session_number | all | local | range list | remote} [detail]]
(Optional) Display information about specified SPAN sessions.
Specify the number of the SPAN or RSPAN session. The range is 1 to 66.
Display all SPAN sessions.
Display only local SPAN sessions.
Display a range of SPAN sessions, where list is the range of valid sessions,
either a single session or a range of sessions described by two numbers, the
lower one first, separated by a hyphen. Do not enter any spaces between
comma-separated parameters or in hyphen-specified ranges.
Note
Display only remote SPAN sessions.
(Optional) Display detailed information about the specified sessions.
Modification
This command was introduced.
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
This keyword is available only in privileged EXEC mode.
OL-9645-10