Config-Vlan Mode; Line Configuration Mode; Slave Configuration; Protocol Specific Modes - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

2.6 Config-VLAN Mode

This mode is used to perform VLAN specific operations. To return to the global configuration
mode the exit command is used.

2.7 Line Configuration Mode

Line configuration commands modify the operations of a terminal line.

2.8 Slave Configuration

This mode is used to generate the Slot information (module type). The reload command is
used to restart the switch.

2.9 Protocol Specific Modes

2.9.1

MSTP Configuration mode

This mode is used to configure the MSTP specific parameters for the switch. The Global
configuration mode command spanning tree mst configuration is used to enter the
MSTP Configuration mode and. the prompt seen at this mode is smis (config-mst)#.
To return to the global configuration mode the exit command is used.
2.9.2

DiffSrv ClassMap Configuration mode

The class-map global configuration command creates a class map to be used for matching the
packets to the class whose index is specified and to enter the class-map configuration mode The
Global configuration mode command class-map <short(1-65535) is used to enter the
DiffSrv ClassMap Configuration mode and. the prompt seen at this mode is SMIS(config-
cmap)#.
To return to the global configuration mode the exit command is used.
2.9.3

DiffSrv Policy-Map Configuration Mode

In the Policy-Map Configuration mode the user can create or modify a policy map.
The Global configuration mode command policy-map <short (1-65535)> is used to enter
the DiffSrv PolicyMap Configuration mode and the prompt seen at this mode is smis (config-
pmap)#.
To return to the global configuration mode the exit command is used.
Release : 1.1f 27 / 985