System Commands - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide
show flow-control
show transceiver
show meminfo

System Commands

Command
device name
system location
system contact
set boot-up
reload
reset-to-factory-defaults
mac-address-table aging-time
copy debugg-logging
debug-logging
no startup-config
show system information
show version
Release : 1.1f
information.
This command displays the flow-control
information.
This command displays the information about
fiber optic transceiver modules.
This command displays the memory status and
utilization.
Description
This command configures the switch name
string.
This command configures the switch location
information string.
This command configures the switch contact
information.
This command configures the next bootup
firmware image selection.
This command restarts the switch.
This command resets the switch to factory
defaults configuration.
This command sets the maximum age of a
dynamically learnt entry in the MAC address
table.
This command writes the debug logs to a
remote site or to external USB memory.
This command configures where debug logs
are to be displayed and the no form of the
command displays debug logs in the console.
This command makes no configuration file will
be loaded in next reboots of the switch.
This command displays system information.
This command displays hardware and firmware
version numbers.
36 / 985