Switchport Mode - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide
15.24

switchport mode

This command configures the VLAN port mode. The no form of the command configures the
default VLAN port mode
switchport mode { access | trunk | hybrid }
no switchport mode
Syntax Description
access - Access port Mode
trunk - Trunk port Mode
hybrid - Hybrid VLAN port Mode
Interface Configuration Mode
Mode -
Defaults
Hybrid Mode
Example
SMIS(config-if)# switchport mode access
It is not possible to set the switchport mode status to Trunk/Hybrid if the tunnel is
enabled.
It is not possible to configure the switchport mode status to trunk if the port is an
untagged member of a VLAN.
Related Commands
switchport mode
dot1q-tunnel - Enables dot1q-tunneling on the specified interface
show vlan port config - Displays the VLAN related parameters specific for ports
Release : 1.1f 362 / 985