Lacp Port-Priority - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

13.4 lacp port-priority

This command sets the LACP port priority and the no form of the command sets the LACP port
priority to the default value. Port priority determines whether the link is an active link or a standby
link, when the number of ports in the aggregation exceeds the maximum number supported by
the hardware
lacp port-priority <0-65535>
no lacp port-priority
Mode
Interface Configuration Mode
Defaults
port-priority - 128
Example
SMIS(config-if)# lacp port-priority 1
This command takes effect only on EtherChannel interfaces that are already
configured for LACP.
If the number of links in an aggregation exceeds the maximum supported by the
hardware, then the links with lower priority become active links.
Related Commands
lacp system-priority - Globally sets the LACP priority
show etherchannel - Displays etherchannel detailed / port information
Release : 1.1f 285 / 985