Interface - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

3.55 interface

This command selects an interface to configure, which can be a physical interface or a port-
channel interface or a VLAN interface or loopback interface. The no form of this command is used
to delete a VLAN / port-channel or loopback interface. On execution of this command, the user
enters the interface configuration mode for that interface.
interface {vlan <vlan-id (1-4069)> | port-channel <port-channel-id (1-
65535)> | <interface-type> <interface-id> | loopback <interface-id (1-
100)> }
no interface { vlan <vlan-id (1-4069)> | port-channel <port-channel-
id(1-65535)> | <interface-type> <interface-id> | loopback <interface-
id (1-100)> }
Syntax Description
vlan - VLAN Identifier any nymber between 1 to 4069
port-channel - Port Channel Identifier any nymber between 1 to 65535
interface-type - Interface type, can either be a gigabit Ethernet or extreme Ethernet (10Gig)
or qx Ethernet (40Gig) interface.
interface-id - Physical interface ID including slot and port number.
loopback - Loopback interface ID any nymber between 1 to 100
Mode
Global Configuration Mode
Defaults
Vlan - 1
interface-type - eth0
Example
For VLAN Interface: SMIS(config)# interface Vlan 2
No port-channels are created by default
Related Command
show interfaces - Displays the interface status and configuration
Release : 1.1f 93 / 985