Command Line Interface - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

2 Command Line Interface

This section describes the configuration of SMIS using the Command Line Interface.
The Command Line Interface (CLI) can be used to configure the Intelligent Switch Solution from a
console attached to the serial port of the switch or from a remote terminal using TELNET.
The SMIS CLI supports a simple login authentication mechanism. The authentication is based on
a user name and password provided by the user during login.
When SMIS is started, the user name and password has to be given at the login prompt to
access the CLI shell:
smis Login: ADMIN
Password: *****
smis>
The "user-exec" mode is now available to the user. CLI Command Modes provide a detailed
description of the various modes available.
When SMIS is started in slave mode on switch stacking, the user name and password has to be
given at the login prompt to access the slave CLI shell:
Supermicro Switch Login: stackuser
Password: ********
smis-boot>
The Boot Configuration mode is now available to the user.
The command prompt always displays the current mode.
Release : 1.1f
Supermicro Intelligent Switch Solution
Supermicro Intelligent Switch Solution
24 / 985