Introduction; Purpose; Scope - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

1 Introduction

1.1 Purpose

The SBM-GEM-X2C, SBM-GEM-X2C+, SBM-GEM-X3S+, and SBM-XEM-X10SM switch
modules are members of Supermicro's SuperBlade® product line. These are Supermicro
Intelligent Switch (SMIS) module products that provide advanced Ethernet connectivity to
SuperBlade modules.
The SSE-G24-TG4, SSE-G48-TG4, SSE-X24S/R and SSE-3348S/R standalone switches are
1U rackmount Ethernet switches – also part the Supermicro Intelligent Switch product line, and
are standalone units.
All of these switches are managed Layer2/Layer 3 switches that share a common switching and
protocol support code base, and provide wire speed switching on each of their 1 Gig and 10 Gig
Ethernet ports.
SMIS provides the basic switching functionality and also offers advanced features such as link
aggregation, GVRP/GMRP, IGMP Snooping, layer 3 unicast and multicast routing for both IPv4
and IPv6.
This guide details the Command Line Interface (CLI) configurations for the features supported in
SMIS. For specific details about any of the Blade switches or the standalone switches, please
refer to their corresponding user guides.

1.2 Scope

The scope of this document is limited to the following Super Micro Intelligent Switch products:

SBM-GEM-X2C

SBM-GEM-X2C+

SBM-GEM-X3S+

SBM-XEM-X10SM

SSE-G24-TG4

SSE-G48-TG4

SSE-X24S

SSE-X24SR

SSE-3348S

SSE-3348SR
Other switch products may be added to these product lines from time to time. It is anticipated that
all will use this base of CLI commands unless otherwise noted.
Release : 1.1f 22 / 985