Dot1X Timeout - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide

10.9 dot1x timeout

This command sets the dot1x timers and the no form of the command sets the dot1x timers to the
default values.
dot1x timeout {quiet-period <value (0-65535)> | {reauth-period |
servertimeout | supp-timeout | tx-period | start-period | held-period |
auth-period }<value (1-65535)>}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-
timeout | tx-period | start-period | held-period | auth-period}
Syntax Description
quiet-period - Number of seconds that the switch remains in the quiet state following a failed
authentication exchange with the client
reauth-period - Number of seconds between re-authentication attempts
server-timeout - Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server
supp-timeout - Number of seconds that the switch waits for the retransmission of packets by
the switch to the client
tx-period - Number of seconds that the switch waits for a response to an EAP-request/identity
frame from the client before retransmitting the request
start-period - Number of seconds that the supplicant waits between successive retries to the
authenticator
held-period - Number of seconds that the supplicant waits before trying to acquire the
authenticator
auth-period - Number of seconds that the supplicant waits before timing-out the authenticator
Mode
Interface Configuration Mode
Defaults
quiet-period - 60 seconds
reauth-period - 3600 seconds
server-timeout - 30 seconds
supp-timeout - 30 seconds
tx-period - 30 seconds
Release : 1.1f 255 / 985