Diffsrv Policy-Map Class Configuration Mode; Dhcp Pool Configuration Mode; Acl Standard Access List Configuration Mode; Acl Extended Access List Configuration Mode - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide
2.9.4

DiffSrv Policy-Map Class Configuration Mode

The Policy-Map Class Configuration command defines a traffic classification for the policy to act
on. The class-map-num that is specified in the policy map ties the characteristics for that class
and its match criteria as configured by using the class-map global configuration command to
the class map. Once the class command is entered, the switch enters policy-map class
configuration mode. The DiffSrv Policy mode command policy-map <short (1-65535)> is
used to enter the DiffSrv Policy-Map Class Configuration mode and. the prompt seen at this
mode is smis (config-pmap-c)#.
To return to the global configuration mode the exit command is used.
2.9.5

DHCP Pool Configuration Mode

This mode is used to configure the network pool / host configurations of a subnet pool.
The Global configuration mode command ip dhcp pool <integer(1-2147483647)>
creates a DHCP server address pool and places the user in DHCP pool configuration mode. The
prompt seen at this mode is SMIS(dhcp-config)#.
To return to the global configuration mode the exit command is used.
2.9.6

ACL Standard Access List Configuration Mode

Standard accesses lists create filters based on IP address and network mask only (L3 filters only
).
The Global configuration mode command ip access-list standard <(1-1000) creates
IP ACLs and is used to enter the ACL Standard Access List Configuration mode. The prompt
seen at this mode is SMIS(config-std-nacl)#.
To return to the global configuration mode the exit command is used.
2.9.7

ACL Extended Access List Configuration Mode

The Extended Access lists enables to specify filters based on the type of protocol, range of
TCP/UDP ports as well as IP address and network mask (Layer 4 filters).
The Global configuration mode command ip access-list extended <(1001-65535)> is
used to enter the ACL Extended Access List Configuration mode and the prompt seen at this
mode is SMIS(config-ext-nacl)#.
To return to the global configuration mode the exit command is used.
2.9.8

ACL MAC Configuration Mode

The MAC access-list global configuration command creates Layer 2 MAC ACLs, and returns the
MACAccess list configuration mode to the user.
Release : 1.1f 28 / 985