Cli Command Modes - Supermicro SSE-G48-TG4 Reference Manual

Super Micro Intelligent Switch Command Line Interface User Guide
CLI commands need not be fully typed. The abbreviated forms of CLI commands are also
accepted by the SMIS CLI. For example, commands like "show ip global config" can be
typed as "sh ip gl co".
CLI commands are case insensitive.
CLI commands will be successful only if the dependencies are satisfied for a particular
command that is issued. Appropriate error messages will be displayed, if the
dependencies are not satisfied

2.1 CLI Command Modes

Command
Mode
User EXEC
Privileged EXEC
Global Configuration
Interface configuration
Config-VLAN
Line Configuration
Release : 1.1f
Access Method
This is the initial mode
to start a session.
The User EXEC mode
command enable, is
used to enter the
Privileged EXEC
mode.
The Privileged EXEC
mode command
configure
terminal, is used to
enter the Global
Configuration mode
The Global
Configuration mode
command
interface
<interfacetype><
interfaceid> is
used to enter the
Interface configuration
mode
The global
configuration mode
command vlan
vlan-id, is used to
enter the Config-
VLAN mode.
The global
configuration mode
command line is
used to enter the Line
Prompt
smis>
SMIS#
SMIS(config)#
SMIS(config-if)#
SMIS(config-
vlan)#
SMIS(config-
line)#
Exit method
The logout method is
used.
To return from the
Privileged EXEC
mode to User EXEC
mode the disable
command is used.
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the Privileged EXEC
mode the end
command is used.
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the Privileged EXEC
mode the end
command is used.
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the privileged EXEC
mode the end
command is used.
To exit to the Global
Configuration mode
the exit command
is used and to exit to
25 / 985