MX2020 3D Universal Edge Router Hardware Guide
Removing the MX2020 Upper Cable Manager
Removing the MX2020 Lower Cable Manager
438
Installing the MX2020 Upper Cable Manager on page 441
5.
Installing the MX2020 DC Cable Manager on page 442
6.
NOTE:
To accommodate additional clearance, you may order an extended
upper cable manager from Juniper Networks.
To remove the upper cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the upper cable manager cover, and remove it.
2.
Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the
3.
upper cable manager.
Grasp the upper cable manager, and pull it straight out from the studs on the front of
4.
the chassis.
Figure 191: Removing the Standard Upper Cable Manager
NOTE:
To accommodate additional clearance, you may order an extended
lower cable manager from Juniper Networks.
Figure 191 on page
438):
Copyright © 2015, Juniper Networks, Inc.