Installing A T640 Cip - Juniper T640 Hardware Manual

Core router
Hide thumbs Also See for T640:
Table of Contents

Advertisement

T640 Core Router Hardware Guide

Installing a T640 CIP

222
To install the CIP (see
Figure 113 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the CIP handle with one hand and hold the bottom edge of the CIP with the
2.
other hand to support its weight.
NOTE:
The components on the CIP are on the left side of the board, unlike
the components of an FPC, which are on the right side. Verify that the
components are on the left before inserting the CIP.
Insert the CIP into the leftmost slot of the FPC card cage, carefully aligning the top
3.
and bottom of the CIP with the guides in the card cage.
Carefully push the CIP straight into the chassis until it contacts the midplane.
4.
Tighten the screws at the top and bottom of the CIP faceplate.
5.
Reattach any external devices connected to the CIP.
6.
CAUTION:
Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet
7.
port on the CIP. If the host module is operational, the
Ethernet activity. If you can run the CLI, the CIP is installed correctly.
223):
ACTIVE
LED blinks to indicate
Copyright © 2013, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents