Juniper T640 Hardware Manual page 151

Hide thumbs Also See for T640:

Table of Contents

Grasp the handles and slide the FPC straight out of the card cage halfway.

Place one hand around the front of the FPC (the PIC housing) and the other hand

under it to support it. Slide the FPC completely out of the chassis, and place it on the

antistatic mat or in the electrostatic bag.

The weight of the FPC is concentrated in the back end. Be

prepared to accept the full weight—up to 32 lb (14.5 kg)—as you slide the

FPC out of the chassis.

When the FPC is out of the chassis, do not hold it by the ejector handles

or edge connectors. They cannot support its weight.

Do not stack FPCs on top of one another after removal. Place each one

individually in an electrostatic bag or on its own antistatic mat on a flat,

stable surface.

Repeat the procedure for each remaining FPC.

Chapter 10: Installing the T640 Router Without a Mechanical Lift

Troubleshooting