Figure 124: Removing the Craft Interface
Copyright © 2013, Juniper Networks, Inc.
Removing the Craft Interface
The craft interface is located on the front of the chassis above the FPC card cage. The
craft interface is hot-removable. To remove the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Completely loosen the screws at the four corners of the craft interface.
2.
Insert the blade of a flat-blade screwdriver into the slot on one side of the craft
3.
interface, then gently pry that side out from the chassis.
Repeat Step
3
for the other side of the craft interface.
4.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
5.
out of the chassis.
Remove the Craft Interface Panel by loosening the four fasteners.
6.
Installing the Air Deflector and Craft Interface
NOTE:
If an air deflector is already installed, installing another air deflector
is not required.
To install the air deflector:
Slide in the air deflector. See
1.
deflector. Four holes align with the four standoffs used for mounting the craft interface.
Replace the craft interface and secure with the four fasteners.
2.
Chapter 17: Replacing T640 Router Hardware Components
Figure 125 on page 240
for proper orientation of air
Figure 124 on page
239):
239