T640 Core Router Hardware Guide
332
Figure 196: Rear of the Power Supply Showing Midplane Connectors
Installing a T640 Six-Input DC Power Supply
Each DC power supply weighs approximately 39.7 lb (18.0 kg). To install a six-input DC
power supply:
Make sure that the voltage across the DC power source cable leads is 0 V and that
1.
there is no chance that the cables might become active during installation.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Using both hands, slide the power supply into the chassis until you feel resistance
3.
(see
Figure 197 on page
Figure 197: Inserting the DC Power Supply into the Chassis
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
4.
until they stop.
Tighten the captive screws at the lower corners of the power supply faceplate to
5.
secure the power supply in the chassis.
332).
Copyright © 2013, Juniper Networks, Inc.