Supplies; Figure 61: Installing The Router In The Rack - Juniper T640 Hardware Manual

Removing the T640 Router Installation Handle and Reinstalling the Power Supplies
Copyright © 2013, Juniper Networks, Inc.

Figure 61: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in a four-post rack.
For an illustration of the mounting hardware required for an open-frame rack,
see Figure 56 on page
After you have installed the T640 router, remove the installation handle and reinstall
the two power supplies in the chassis, starting with the lower power supply:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the installation handle completely, and remove the
2.
handle from the chassis.
Switch the circuit breakers on the two-input 160-A, three-input 240-A, or four-input
3.
240-A power supply faceplate to the off position (
power supplies or six-input DC power supplies to the standby position.
Using both hands, slide the power supply into the chassis until you feel resistance.
4.
Chapter 9: Installing the T640 Router Using a Mechanical Lift
97.
), or the power switch on the AC
O
107