Copyright © 2013, Juniper Networks, Inc.
Press the tab on the connector and pull the connector straight out of the
1.
port.
Figure 115 on page 226
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
labeled
connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
and the ports labeled
HOST 1
Engine slot (
RE1
).
Plug the other end of the cable into the network device.
4.
Chapter 17: Replacing T640 Router Hardware Components
shows the connector.
connect to the Routing Engine in the lower Routing
ETHERNET
ETHERNET
port. The ports
),
RE0
225