Figure 64: Removing the CIP
Installing an M320 CIP
Copyright © 2010, Juniper Networks, Inc.
To install the CIP (see Figure 65 on page 142):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the site ESD points on the chassis.
Grasp the CIP handle with one hand and hold the bottom edge of the CIP with the
2.
other hand to support its weight.
NOTE: The components on the CIP are on the left side of the board, unlike
the components of an FPC, which are on the right side. Verify that the
components are on the left before inserting the CIP.
Insert the CIP into the leftmost slot of the FPC card cage, carefully aligning the top
3.
and bottom of the CIP with the guides in the card cage.
Carefully push the CIP straight into the chassis until it contacts the midplane.
4.
Chapter 13: Replacing the M320 Router Hardware Components
141