Setting The Input Mode Switch On A Three-Input 240-A Dc Power Supply For A T640 Router; Figure 180: Rear Of The Power Supply Showing Midplane Connectors; Figure 181: Removing A Three-Input 240-A Dc Power Supply - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
316
WARNING: Do not touch the power connectors on the rear of the power
supply (see Figure 180 on page

Figure 180: Rear of the Power Supply Showing Midplane Connectors

Figure 181: Removing a Three-Input 240-A DC Power Supply

Setting the Input Mode Switch on a Three-Input 240-A DC Power Supply for a
T640 Router
NOTE: Do not set the input mode switch if the power supply is installed in
the chassis. If the power supply is already installed, you must disconnect all
cables and remove the power supply before setting the input mode switch.
316). They can contain dangerous voltages.
Copyright © 2013, Juniper Networks, Inc.