Copyright © 2013, Juniper Networks, Inc.
Table 51: Tools and Parts Required for Component
Replacement (continued)
Components
AC power supply
AC power supply cord
Air filter (front or rear)
CIP
Control board
Craft interface
DC power supply
DC power supply cable
Fan tray (front or rear)
FPC
Chapter 17: Replacing T640 Router Hardware Components
Tool or Part
Phillips (+) screwdriver, number 2
1/4-in. slotted screwdriver or 5/32-in. (4 mm)
allen wrench
NOTE:
The terminal connections have either
slotted screws or hex screws. Use a 1/4-in.
slotted screwdriver for the slotted screws. Use
a 5/32-in (4-mm) Allen wrench for the 5/16-in
hex screws.
Phillips (+) screwdriver, number 2
1/4-in. slotted screwdriver or 5/32-in. (4 mm)
allen wrench
NOTE:
The terminal connections have either
slotted screws or hex screws. Use a 1/4-in.
slotted screwdriver for the slotted screws. Use
a 5/32-in (4-mm) Allen wrench for the 5/16-in
hex screws.
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
7/16-in. (11 mm) nut driver
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Blank panel (if component is not reinstalled)
Electrostatic bag or antistatic mat
219