Installing A T640 Fpc; Figure 165: Removing A T640 Fpc - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
290

Figure 165: Removing a T640 FPC

Installing a T640 FPC

To install an FPC (see Figure 167 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the FPC on an antistatic mat.
2.
Take each PIC to be installed in the replacement FPC out of its electrostatic bag, and
3.
identify the slot on the FPC where it will be connected.
Verify that each fiber-optic PIC has a rubber safety cap covering the PIC transceiver.
4.
If it does not, cover the transceiver with a safety cap.
Install each PIC into the appropriate slot on the FPC. For information on installing a
5.
PIC, see "Installing a T640 PIC" on page
Locate the slot in the FPC card cage in which you plan to install the FPC.
6.
293):
296.
Copyright © 2013, Juniper Networks, Inc.