Figure 53: Contents Of The T640 Shipping Crate - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Related
Documentation
88
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate cover and set it aside.
4.
Slide the remainder of the shipping crate cover off the pallet.
5.
Remove the foam covering the top of the router.
6.
Remove the accessory box and the Quick Start documentation.
7.
Verify the parts received.
8.
Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being careful
9.
not to break the VCI packs open.
To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket wrench
10.
and a number 2 Phillips screwdriver to remove the bolts and screws from the brackets.
Store the brackets and bolts inside the accessory box.
11.
Save the shipping crate cover, pallet, and packing materials in case you need to move
12.
or ship the router at a later time.
Proceed with the installation.
13.

Figure 53: Contents of the T640 Shipping Crate

T640 Chassis Description on page 13
Verifying the T640 Router Parts Received on page 89
Copyright © 2013, Juniper Networks, Inc.