Engine; Figure 158: Removing A Compactflash Card - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
276
Removing a CompactFlash Card in a T640 RE-C1800 Routing Engine
The CompactFlash card is located in the slot labeled
To remove the CompactFlash card (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Verify that the ,
2. Online DISK1
are off.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Using a Phillips (+) screwdriver, number 2, loosen the captive screws on the corners
4.
of the cover over the Routing Engine slots.
Remove the cover from the Routing Engine slots.
5.
CAUTION: Do not remove the cover if any of the LEDs are lit.
Press the eject button on the right side of the CompactFlash card slot to release the
6.
CompactFlash card.
The CompactFlash card pops partially out of the slot. Grasp the card and pull it
7.
completely out of the slot.
Place the CompactFlash card on the antistatic mat.
8.

Figure 158: Removing a CompactFlash Card

Installing a CompactFlash Card in a T640 RE-C1800 Routing Engine
To install a CompactFlash card (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the cover from the Routing Engine slots by loosening the captive screws on
2.
the corners of the cover (using a Phillips (+) screwdriver, number 2).
Insert the CompactFlash card into the CompactFlash card slot on the Routing Engine,
3.
with the logo facing up.
on the Routing Engine faceplate.
CF
Figure 158 on page
, and LEDs on the backup Routing Engine faceplate
CF
Figure 159 on page 277):
Copyright © 2013, Juniper Networks, Inc.
276):