Installing A T640 Cip; Figure 83: Removing A Cip - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Installing a T640 CIP

178

Figure 83: Removing a CIP

To install the CIP (see Figure 84 on page 179):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the CIP handle with one hand and hold the bottom edge of the CIP with the
2.
other hand to support its weight.
NOTE: The components on the CIP are on the left side of the board, unlike
the components of an FPC, which are on the right side. Verify that the
components are on the left before inserting the CIP.
Insert the CIP into the leftmost slot of the FPC card cage, carefully aligning the top
3.
and bottom of the CIP with the guides in the card cage.
Copyright © 2010, Juniper Networks, Inc.