Holding And Storing T640 Fpcs; Holding T640 Fpcs - Juniper T640 Hardware Manual

Related
Documentation

Holding and Storing T640 FPCs

Copyright © 2013, Juniper Networks, Inc.
user@host> show chassis fpc detail 0
Slot 0 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
For further description of the output from the commands, see show chassis environment
fpc.
T640 Chassis Description on page 13
T640 FPC Description on page 17
T640 Craft Interface FPC LEDs and Online/Offline Buttons on page 55
Holding T640 FPCs on page 187
Storing T640 FPCs on page 190

Holding T640 FPCs

CAUTION: Many components on the FPC are fragile. Failure to handle FPCs
as specified in this document can cause irreparable damage.
NOTE: An FPC configured with PICs installed can weigh as much as 29 lb
(13.2 kg). Be prepared to accept the full weight of the FPC as you lift it.
To prevent damage when handling or carrying FPCs:
As you carry the FPC, do not bump it against anything. FPC components are fragile.
Do not grasp the FPC anywhere except places that this document indicates. In particular,
never grasp the connector edge, especially at the power connector in the corner where
the connector and bottom edges meet (see
Chapter 15: Maintaining T640 Router Hardware Components
Online
23 degrees C / 73 degrees F
256 MB
36 MB
640 MB
2008-12-12 11:02:43 PST
5 hours, 18 minutes, 51 seconds
Figure 107 on page 188).
187