Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
T640 Chassis Description on page 13
Replacing a T640 Standard Control Board or T-CB on page 259
Maintaining the T640 Control Boards on page 184
T640 T Series Control Boards (T-CBs) Description
Each T-CB consists of the following components:
100-MB Ethernet switch for intermodule communication.
PCI bus to the Routing Engines.
Processor subsystem (SPMB).
Figure 24 on page 45
shows the T-CB.
Figure 24: T-CB
The following components are located on the T-CB faceplate:
The
,
, and
MASTER
FAIL
Online/offline button.
NOTE:
When the adjacent Routing Engine is online, the online/offline
button on the T-CB faceplate is nonfunctional. For more information, see
"Taking the T640 Host Subsystem Offline" on page
Two RJ-45 ports labeled
For T640 routers connected to a TX Matrix platform, only the
information, see the
TX Matrix Router Hardware Guide
The
and
M/S
CHASSIS ID
For a standalone T640 router, the
always be set to
and
S
Chapter 3: T640 Router Hardware Component Overview
LEDs, which indicate the status of the T-CB.
OK
and
on the T-CB faceplate.
AUX
CIP
configuration switches.
M/S
and
CHASSIS ID
.
0
256.
port is used. For more
CIP
.
configuration switches must
45