T640 Core Router Hardware Guide
326
Figure 189: Removing a Four-Input 240-A DC Power Supply
WARNING:
Do not touch the power connectors on the rear of the power
supply (see
Figure 190 on page
Figure 190: Rear of the Power Supply Showing Midplane Connectors
Installing a T640 Four-Input 240-A DC Power Supply
Each four-input 240-A DC power supply weighs approximately 26.6 lb (12.0 kg). To install
a four-input 240-A DC power supply:
Make sure that the voltage across the DC power source cable leads is 0 V and that
1.
there is no chance that the cables might become active during installation.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on the power supply faceplate to the
3.
326). They can contain dangerous voltages.
OFF
Copyright © 2013, Juniper Networks, Inc.
position (
).
O