Figure 166: Installing An Fpc - Juniper T640 Hardware Manual

Copyright © 2013, Juniper Networks, Inc.
Inspect the slot in the FPC card cage to verify that there are no missing or bent pins
7.
on the midplane.
Inspect the FPC to verify that the connectors are not misaligned or damaged.
8.
CAUTION: When the FPC is out of the chassis, do not hold it by the ejector
handles or edge connectors. They cannot support its weight.
Verify that the FPC is right-side up, with the components on the right of the FPC.
9.
Lift the FPC into place and carefully align the bottom and top of the FPC with the
10.
guides inside the card cage.

Figure 166: Installing an FPC

Gently rest the bottom edge of the FPC on the bottom edge of the slot opening, making
11.
contact a short distance forward of the power connector.
CAUTION: Take care not to bend or otherwise damage the power
connector prongs.
Chapter 17: Replacing T640 Router Hardware Components
Do not bend or damage prongs
on power connector
291