Replacing The T640 Cip; Removing A T640 Cip - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Related
Documentation

Replacing the T640 CIP

Removing a T640 CIP

220
Table 51: Tools and Parts Required for Component
Replacement (continued)
Components
PIC
Routing Engine
Serial cable to or
AUXILIARY
Engine port
Standard SIB or T640-SIB
SCG
T640 Chassis Description on page 13
Returning a Hardware Component to Juniper Networks, Inc. on page 461
Removing a T640 CIP on page 220
1.
Installing a T640 CIP on page 222
2.
The CIP is located to the left side of the FPC card cage. It houses the Routing Engine
interface ports, which accept connections to external management and alarm-reporting
devices.
The CIP is hot-pluggable. It weighs approximately 8 lb (3.6 kg). When the CIP is removed,
you cannot control or communicate with the router using an external device.
To remove the CIP (see Figure 112 on page
Tool or Part
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic PICs or
fiber-optic PIC cables
Flat-blade (–) screwdriver for Type 1 PICs
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Routing Flat-blade (–) screwdriver
CONSOLE
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
221):
Copyright © 2013, Juniper Networks, Inc.