Figure 64: Removing the CIP
Installing the CIP
To install the CIP, follow this procedure (see Figure 65):
1.
2.
NOTE: The components on the CIP are on the left side of the board, unlike the
components of an FPC, which are on the right side. Verify that the components are
on the left before inserting the CIP.
3.
Verify that the router is powered down.
Carefully insert the rear of the CIP into the guides at the top and bottom of the
CIP slot, which is located to the left of the FPC card cage.
Slide the CIP into the chassis until it contacts the midplane.
Replacing the CIP and Routing Engine Interface Port Cables
Replacing Hardware Components
143