Figure 220: Installing A Three-Phase Delta Ac Power Supply - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Related
Documentation
360
Connect the AC power cord plug to the power source.
18.
Switch on the customer site circuit breakers to provide voltage to the AC power cord.
19.
Remove the ESD grounding strap from the approved site ESD grounding point. See
20.
the instructions for your site. Reconnect the strap to one of the ESD points on the
chassis.
Verify that the AC OK LED on the power supply faceplate is lit steadily, indicating that
21.
the AC terminal block is receiving power.
Switch the power switch on the power supply to the
22.
to the router components.
Verify that the LED on the power supply faceplate is lit steadily, indicating that
23. DC OK
the power supply is correctly installed and is functioning properly. The
blinks momentarily, then lights steadily.
NOTE: After a power supply is powered on, it can take up to 60 seconds
for status indicators—such as the LEDs on the power supply, the command
output displays, and messages on the LED display on the craft interface—to
indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.

Figure 220: Installing a Three-Phase Delta AC Power Supply

T640 Three-Phase Delta and Wye AC Power Supply Description on page 71
T640 Three-Phase Delta and Wye AC Power Supply LEDs on page 74
Troubleshooting the T640 Power System on page 207
T640 Preventing Electrostatic Discharge Damage on page 386
position ( ) to provide power
ON |
LED
DC OK
Copyright © 2013, Juniper Networks, Inc.