Performing The Initial T640 Junos Os Configuration; Preparing To Configure The T640 Router; Initially Configuring The T640 Router - Juniper T640 Hardware Manual

CHAPTER 14
Performing the Initial T640 Junos OS
Configuration

Preparing to Configure the T640 Router

Related
Documentation

Initially Configuring the T640 Router

Copyright © 2013, Juniper Networks, Inc.
Preparing to Configure the T640 Router on page 171
Initially Configuring the T640 Router on page 171
Configuring DC Power on a T640 Router on page 175
Gather the following information before configuring the router:
Name the router will use on the network
Domain name the router will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Initially Configuring the T640 Router on page 171
The T640 Core Router is shipped with the Junos OS preinstalled and ready to be
configured when the T640 router is powered on. These procedures connect a router to
the network but do not enable it to forward traffic. For complete information about
enabling the router to forward traffic, including examples, see the Junos OS configuration
guides.
You configure the router by issuing Junos OS command-line interface (CLI) commands,
either on a console device attached to the
connection to a network connected to the
port on the CIP, or over a telnet
CONSOLE
ETHERNET port on the CIP.
171