Removing The T640 Cable Management System; Figure 68: Removing The Rear Fan Tray - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Removing the T640 Cable Management System

116

Figure 68: Removing the Rear Fan Tray

The cable management system is located below the FPC card cage. The cable
management system weighs approximately 5 lb (2.3 kg).
To remove the cable management system:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Using a 3/8-in. nut driver, unscrew the nuts on the corners of the cable management
2.
system.
Grasp the bottom of the cable management system and pull it straight out from the
3.
studs on the front of the chassis.
Copyright © 2013, Juniper Networks, Inc.