Copying The Junos Os To The Compactflash Card In A T640 Re-C1800 Routing Engine; Figure 159: Installing A Compactflash Card - Juniper T640 Hardware Manual

Copyright © 2013, Juniper Networks, Inc.
CAUTION: Be sure to insert the CompactFlash card with the label facing
up. Inserting the CompactFlash card incorrectly might damage the Routing
Engine.
Press the card firmly all the way into the slot.
4.
Reinstall the Routing Engine cover. Using a Phillips (+) screwdriver, number 2, tighten
5.
the screws on the corners of the cover to secure it to the Routing Engine.
From the master Routing Engine, power on the Routing Engine. For a standalone router,
6.
issue the request system power-on other-routing-engine
NOTE: After you replace a CompactFlash card, the Routing Engine boots
from the solid-state disk (SSD). You may get an error message and be
prompted for a keystroke. After you press the keystroke, it might take up
to 10 minutes for the Routing Engine to reset and for the router to boot
from the SSD.

Figure 159: Installing a CompactFlash Card

Copying the Junos OS to the CompactFlash Card in a T640 RE-C1800 Routing
Engine
After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's solid-state disk (SSD) to the CompactFlash card.
NOTE: For more information about the commands for this procedure, see
request system snapshot, request system reboot, and show system
boot-messages.
To copy software to the CompactFlash card:
On the console or other management device connected to the Routing Engine, enter
1.
CLI operational mode.
Copy the currently running and active file system partitions on the router to standby
2.
partitions on the CompactFlash card. Issue the
command.
Chapter 17: Replacing T640 Router Hardware Components
command.
request system snapshot partition
277