Connecting The T640 Router To An External Alarm-Reporting Device; Connecting The T640 Router To A Network For Out-Of-Band Management - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Connecting the T640 Router to an External Alarm-Reporting Device

Related
Documentation

Connecting the T640 Router to a Network for Out-of-Band Management

138
To connect the router to external alarm-reporting devices, attach wires to the
and relay contacts on the CIP. A system condition that triggers the red
YELLOW ALARM
or yellow alarm LED on the craft interface also activates the corresponding alarm relay
contact.
The terminal blocks that plug into the alarm relay contacts are supplied with the router.
They accept wire of any gauge between 28-AWG and 14-AWG (0.08 and 2.08 mm
which is not provided. Use the gauge of wire appropriate for the external device you are
connecting.
To connect an external device to an alarm relay contact:
Prepare the required length of wire with gauge between 28-AWG and 14-AWG (0.08
1.
2
and 2.08 mm ).
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
While the terminal block is not plugged into the relay contact, use a 2.5-mm flat-blade
3.
screwdriver to loosen the small screws on its side. With the small screws on its side
facing left, insert wires into the slots in the front of the block based on the wiring for
the external device. Tighten the screws to secure the wire.
Orient the terminal block according to the labels to the left of the appropriate relay
4.
contact ( means "normally closed,
NC
open").
Plug the terminal block into the relay contact and use a 2.5-mm flat-blade screwdriver
5.
to tighten the screws on the face of the block.
Attach the other end of the wires to the external device.
6.
If attaching a reporting device for the other kind of alarm, repeat the procedure.
Overview of Connecting the T640 Router to External Devices on page 135
T640 Routing Engine Interface Cable and Wire Specifications on page 448
Tools and Parts Required to Connect the T640 Router to External Devices on page 136
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet with RJ-45 connectors to the
with the router.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Turn off the power to the management device.
2.
means "common," and (
C
port on the CIP. One cable is provided
ETHERNET
Copyright © 2013, Juniper Networks, Inc.
RED ALARM
2
),
means "normally
NO