Figure 244: Three-Phase Wye Ac Power Cord - Juniper T640 Hardware Manual

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.

Figure 244: Three-Phase Wye AC Power Cord

NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 14.75 ft) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the router are in
compliance.
WARNING: The router is pluggable type A equipment installed in a
restricted-access location. It has a separate protective earthing terminal
(sized for UNC 1/4-20 ground lugs) provided on the chassis in addition to the
grounding pin of the power supply cord. This separate protective earthing
terminal must be permanently connected to earth.
CAUTION: Power cords and cables must not block access to device
components or drape where people could trip on them.
Connecting AC Power to a T640 Router with Three-Phase Wye AC Power Supplies on
page 165
Connecting AC Power to a T640 Router with Three-Phase Delta AC Power Supplies
on page 163
Replacing a T640 Three-Phase Delta AC Power Supply Cord on page 361
Replacing a T640 Three-Phase Wye AC Power Supply Cord on page 370
T640 Three-Phase Delta AC Power Supply Specifications on page 436
T640 Three-Phase Wye AC Power Supply Specifications on page 437
Appendix D: T640 Power Guidelines, Requirements, and Specifications
441