Related
Documentation
T640 Three-Input 240-A DC Power Supply LEDs
Copyright © 2013, Juniper Networks, Inc.
Table 29: Fault Tolerance
Redundancy
Nonredundant power supply
Redundant power supplies
T640 Power System Description on page 60
Powering On a DC-Powered T640 Router on page 162
Maintaining the T640 Power Supplies on page 194
LEDs on each power supply faceplate (see
the power supply. In addition, a power supply failure triggers the red alarm LED on the
craft interface.
Table 30 on page 65
Figure 36: Three-Input 240-A DC Power Supply LEDs
Table 30 on page 65
describes the three-input 240-A DC power supply LEDs.
Table 30: Three-Input 240-A DC Power Supply LEDs
LED
Color
CB ON
—One per
Green
input
Chapter 3: T640 Router Hardware Component Overview
Fault Tolerance When One Input Fails or is Disconnected
If this input fails, the router shuts down.
NOTE:
We recommend that you install redundant power
supplies.
If an input on one power supply fails, the other power supply
assumes the electrical load for all inputs. If one input on the other
power supply is not functional, the router shuts down.
Figure 36 on page
describes the functions of the power supply LEDs.
State
Description
On steadily
Circuit breaker is on.
Off
Circuit breaker is not turned on, or
host subsystem has detected a
failure and has turned the circuit
breaker off.
65) indicate the status of
65