Installing the M40e CIP
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Using a Phillips screwdriver, loosen and remove the screw at each end of the CIP
6.
faceplate.
Grasp the CIP and slide it out of the chassis. Place it in the electrostatic bag or on the
7.
antistatic mat.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
Figure 78: Removing the M40e CIP
To install the CIP (see Figure 79 on page 162):
Verify that the router is powered down.
1.
Carefully insert the rear of the CIP into the guides at the top and bottom of the CIP
2.
slot, which is located to the left of the FPC card cage.
NOTE: The components on the CIP are on the left side of the board, unlike
the components of an FPC, which are on the right side. Verify that the
components are on the left before inserting the CIP.
Chapter 16: Replacing M40e Hardware Components
161