Show Ip Ospf Interface - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

show ip ospf interface

Display the OSPF interfaces configured. If OSPF is not enabled on the switch, no output is generated.

show ip ospf [process-id | vrf vrf-name] interface [interface]

vrf vrf-name

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.4.

Version 9.0.2.0

Version 8.3.11.1

Open Shortest Path First (OSPFv2 and OSPFv3)

Enter the OSPF Process ID to show a specific process. If no

Process ID is entered, command applies only to the first

OSPF process.

Enter the keyword vrf followed by the name of the VRF to

show the OSPF processes that are tied to a specific VRF.

(OPTIONAL) Enter the following keywords and slot/port or

number information:

For the null interface, enter the keyword null then zero

For loopback interfaces, enter the keyword loopback

then a number from 0 to 16383.

For tunnel interfaces, enter the keyword tunnel then a

number from 0 to 16383.

For Port Channel groups, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN, enter the keyword vlan then the VLAN ID.

The range is from 1 to 4094.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

EXEC Privilege

Added support for VRF.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.