3Com 3C13636 Configuration Manual page 464

3Com Router 3000 Ethernet Family
Configuration Guide
Table 9-3 Set the current interface to operate in DHCP server mode
Send DHCP packets to the local DHCP
server and allocate addresses from the
global address pool
Send DHCP packets to the local DHCP
server and allocate addresses from the
interface address pool
Restore the default
Note:
These commands must be performed on an Ethernet interface (subinterface), virtual
Ethernet interface, synchronous/asynchronous serial interface encapsulated with PPP,
HDLC or frame relay, or E1 interface.
Perform the following configuration in the system view to have the specified interfaces
operate in DHCP server mode.
Table 9-4 Set multiple interfaces to operate in DHCP server mode
Send DHCP packets to the local DHCP
server and allocate addresses from the
global address pool
Send DHCP packets to the local DHCP
server and allocate addresses from the
interface address pool
Resets the default
By default, dhcp select global applies. Currently DHCP server is available on
following interfaces:
Ethernet interface (subinterface)
Virtual Ethernet interface
Synchronous/asynchronous serial interface encapsulated with PPP, HDLC, or
frame relay
E1 interface
Operation
Operation
3Com Corporation
9-17
Chapter 9 DHCP Configuration
Command
dhcp select global [ subaddress ]
dhcp select interface
undo dhcp select
Command
dhcp select global [ subaddress ]
{ interface
interface-number [ to interface-type
interface-number ] | all }
dhcp select interface
interface-type interface-number
interface-type interface-number ] | all }
undo dhcp select
interface-type interface-number
interface-type interface-number | all }
interface-type
{ interface
[ to
{ interface
[ to